Woodnet Forums › › Active › Woodworking v
Pipe Cutter
Thread Modes
Pipe Cutter
Foggy Offline
figgerer
Posts: 2,742
Threads: 0
Joined: Jan 2010
#12
01-03-2019, 06:43 PM
I have had my cutter do spirals a couple of times. Each time the screws holding the rollers were loose. Tightened them and all was ok.

My boss is a Jewish carpenter. Our DADDY owns the business.
Trying to understand some people is like trying to pick up the clean end of a turd.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.