05-04-2019, 10:45 PM
I volunteer at a retirement community wood shop. I got a call from one of the residents who is a frequent user of the shop. He was a bit hesitant to tell me what had prompted him to call me at home. We have a small Craftsman router table with a Makita 3606 trim router installed in it. At some point the collet locking pin fell out (a 'c' clip came loose) and we have been using a pocket screwdriver with the tip ground flat to lock the collet for bit changes.
The resident said he had been vacuuming up the debris around the router table after doing some edge routing. He had not put the modified screwdriver back in its storage location (just a hole in the router stand) before sweeping the area with the vacuum. He couldn't find the screwdriver. Even after dumping out the contents of the Dust Deputy bucket and shaking out the hose.
He was very concerned about loosing this specialized tool and I assured him I would stop by tomorrow and see if we can find the missing tool. I also told him that screwdriver had been in my possession - mostly gathering dust - for about 20 years.
Bill
The resident said he had been vacuuming up the debris around the router table after doing some edge routing. He had not put the modified screwdriver back in its storage location (just a hole in the router stand) before sweeping the area with the vacuum. He couldn't find the screwdriver. Even after dumping out the contents of the Dust Deputy bucket and shaking out the hose.
He was very concerned about loosing this specialized tool and I assured him I would stop by tomorrow and see if we can find the missing tool. I also told him that screwdriver had been in my possession - mostly gathering dust - for about 20 years.
Bill
