I made a dumb error
#14
Post a pic of each end of the motor. You need the screw out, but disassembling that motor is not difficult.
Waiting to grow up beyond being just a member
www.metaltech-pm.com
Reply
#15
Thanks for the offer. Here is another end.


Attached Files Image(s)
   
   
"Life is too short for bad tools.".-- Pedder 7/22/11
Reply
#16
Make a couple of marks from the case to the rear bell to help in aligning things back together. Remove the 4 bolts that hold the motor together. You should be able to slide the rear end bell off about an inch with no further disassembly needed. The screw should be easy to grab or shake out at that point. Back together and give her a healthy dose of compressed air to clear the accumulated dust.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.