rabbet trick (or #140 trick) vs. alignment board
#12
  Re: RE: rabbet trick (or #140 trick) vs. alignment board by C. in Indy (Aside from the overa...)
(09-02-2019, 12:28 PM)C. in Indy Wrote: Aside from the overall necessity question....

If you're making a box/drawer with full dovetails, and you want to accommodate stopped grooves inside, the rabbeting trick is great.




Chris

Thank you for that piece of information. I am just thinking here, that would hid the grooves but it would change the length of the pin board. I am just considering through dovetails with an applied front but it would work without an applied front if one wanted to use part of the dovetails as a focal point. I will have to play with this idea. Probably would have never considered it on my own.

Thanks again.

Tom
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)