Posts: 463
Threads: 0
Joined: Oct 2007
Here are some pictures of the motor that came with my latest band saw. It came out of a shop where it was cutting aluminum. The saw, pulleys, and stand were all relatively clean and grease free. The motor, however, was covered in a mixture of black grease and aluminum dust. The pictures of the motor are after it's initial clean up. The whole motor looked like the picture showing the wiring connections, which did not have a cover. The motor spins freely and makes no noise, but I am afraid to power it up. The motor weighs about twice as much as the 1/4 hp Craftsman motor in the saw pictures in the other post. Should I just take off the pulley and scrap the motor?
Posts: 2,036
Threads: 1
Joined: Aug 2016
(09-16-2019, 02:34 PM)pgriff Wrote: Here are some pictures of the motor that came with my latest band saw. It came out of a shop where it was cutting aluminum. The saw, pulleys, and stand were all relatively clean and grease free. The motor, however, was covered in a mixture of black grease and aluminum dust. The pictures of the motor are after it's initial clean up. The whole motor looked like the picture showing the wiring connections, which did not have a cover. The motor spins freely and makes no noise, but I am afraid to power it up. The motor weighs about twice as much as the 1/4 hp Craftsman motor in the saw pictures in the other post. Should I just take off the pulley and scrap the motor?
Clean the grease and aluminum chips out of the terminal box, put a ground on the motor frame connect it up and see what happens. secure the motor to something so that when it starts up it won't twist off of a table. The most that could happen is that the breaker trips. Probably a good motor. Roly
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
I would clean it and try it. If it doesn't run, I would have a motor shop fix or rebuild it.
I would never expect a new motor to be anywhere near as good as that motor.
Posts: 19,110
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
(09-16-2019, 09:37 PM)daddo Wrote: I would never expect a new motor to be anywhere near as good as that motor.
Exactly, they hadn't perfected the art of making chitty motors until many years/decades later.
Posts: 116,861
Threads: 0
Joined: Jun 2002
Location: Sparkling Clearwater, Fl. Tampa Bay Area
Often Tested. Always Faithful. Brothers Forever
Jack Edgar, Sgt. U.S. Marines, Korea, America's Forgotten War
Get off my lawn !
Posts: 463
Threads: 0
Joined: Oct 2007
I will try cleaning it out this weekend and let you know the results.
