"Shifting Meridian"
#20
That's slick how the staves magically switched from being lined up in the glue-up to being offset in the turned piece.

Beautiful work.

How many staves are there in one layer?
We do segmented turning, not because it is easy, but because it is hard.
Reply
#21
(10-16-2019, 07:28 AM)SceneryMaker Wrote: That's slick how the staves magically switched from being lined up in the glue-up to being offset in the turned piece.

Beautiful work.

How many staves are there in one layer?

Thanks again everyone,.... There are 35 pieces in each row they were cut and hand sanded on both sides up to 320 grit from a saw cut that's 140 surfaces before it was glued up I used thin CA.  I also sealed all of them w/ CA this made them stronger for the hollowing process and after I sanded them once again w/ 320 sand paper on a tong depressor before finishing.
Reply
#22
I too noticed the change from the staves being lined up to being offset.???? Either way a beautiful piece
Reply
#23
(10-16-2019, 04:19 PM)Turner52 Wrote: I too noticed the change from the staves being lined up to being offset.???? Either way a beautiful piece

This is due to the radius cut of the sphere, the pieces are not cut on an angle they taper in toward the center the gap gets smaller as they go in toward the center.


Attached Files Image(s)
   
Reply
#24
I had a few requests on other sites to see the top & bottom better so here's a few more shots.


Attached Files Image(s)
   
   
   
   
Reply
#25
(10-16-2019, 04:19 PM)Turner52 Wrote: I too noticed the change from the staves being lined up to being offset.???? Either way a beautiful piece

He split the middle ring, rotated it, and glued it together again
Nice work Bruce
Life is what you make of it, change your thinking, change your life!
Don's woodshop
Reply
#26
(10-18-2019, 08:08 AM)Woodshop Wrote: He split the middle ring, rotated it, and glued it together again
Nice work Bruce

Thanks Woodshop....  I thought Tunner 52 was talking about the taper in the slots, yes as woodshop said I cut it apart in the center and reglued it 

offset hence the name "Shifting Meridian"
Reply
#27
That is a very nice piece! Great job.
Reply
#28
Thank you woodchips
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.