Help me design a double router table top
#7
  
For a long time I've had two benchtop router tables sitting on a cart and I've decided to clean up this set-up and want to run my ideas thru the WN braintrust. I am pretty set on having two routers in one top as I've gotten used to having 2 routers set up for matched bits, etc. I'm going to need to buy some parts, but some of the parts will be scavenged off my current tables. Below are my ideas, and would appreciate any feedback, criticism, etc.
  • top will be 1/2 solid surface material glued to 2x 3/4" MDF (I have a piece of 30"x48" solid surface material that I'm not using)
  • fence #1 will be Lee Valley split fence that I already own, fence #2 will be 80/20 extrusion that I have ordered. Will need to buy 2"x3" aluminum angle extrusion to hold the fences together and allow for attachment to table
  • Plan on buying combination t-track/ miter slot for each side- What are the optimum dimensions away from the bit to put the miter fence?
  • I'm going to buy at least one lift for a PC 890 router- 99% sure a Jessem Router Lift 2. The other router I want to use is a Hitachi M12V. Looking at either a router lift or router raizer for this one.
  • Planning on building a Norm style cabinet for this top to sit on
  • Any thoughts on the dimensions of the top shown below? I'm trying to optimize the sheet of SS that I have is basically how I came up with these dimensions, but I can't go too big either because space is an issue in my shop.
  • Any thoughts about any of my other ideas?

   
Reply
#8
  Re: Help me design a double router table top by ajkoontz (For a long time I've...)
The November 2019 WOOD Magazine has an article on the build of a two (or more) router table and top.
Reply
#9
  Re: Help me design a double router table top by ajkoontz (For a long time I've...)
Thanks for the Wood Magazine heads-up. I like the trim router idea. Would be nice to incorporate that with round over bit installed.
Reply
#10
  Re: Help me design a double router table top by ajkoontz (For a long time I've...)
First one is set up for rails and stiles. There's 2 PC 7537's under there.

   
   
   
   

Second one is/was for doing door round overs, edge profiles, and general use.

Pics were taken before I got the top upper dust system on.

   
   
   



I used old lower kitchen cabs and made the tops.
All 4 routers have the Rockler alum inserts.
Steve





Working on 20,000 Winkgrin





Reply
#11
  Re: Help me design a double router table top by ajkoontz (For a long time I've...)
Love it. Anything you would do differently on the first one?
Reply
#12
  Re: Help me design a double router table top by ajkoontz (For a long time I've...)
Build a better, wider cabinet box for more storage
Steve





Working on 20,000 Winkgrin





Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)