A few items for sale here. There are also a few free items (just pay shipping). Priority on free items to people purchasing another item.
First PM that says "I'll take it" gets it. Check or PayPal (buyer covers fees). Shipping is from 22153 (northern Virginia).
1. Stanley/Bell System 2101A 10" brace. Great brace, just a duplicate for me. I've opened this up, cleaned out the old, gummed up grease, and re-lubricated it. Ratcheting mechanism works smoothly. $35 + shipping.
2. Miller Falls 772 10" brace with a Lion chuck. Essentially the same description as above. $35 + shipping.
3. 4" slick/chisel with a socket. Ok, it's actually 3-7/8" wide. About 13" long. "Mallet Cast Steel" is stamped on the top (see picture). The cutting edge is currently dull and has a couple chips that will need to be sharpened out (see picture). Based on my file skating along the cutting edge, it is indeed hardened and there appears to be a faint line (about 1.5" from the edge) where the hardened steel for the edge is welded to a softer steel for the body (I assume), similar to old hand plane blades. Still plenty of life. It looks like someone hit the socket end with a hammer a few times, so that will need to be cleaned up, but it's not horrible. Reasonable pricing on these is really hard to figure out and seems to go up exponentially with the width of the slick. How about $90 + shipping. Let me know if I'm way out of line. I tried to be reasonable based on the info that I could find.
4. Leecraft phenolic zero clearance insert, model DL-2. 3-3/4" x 12-1/2". Fits Delta 10" direct drive (#34-670, #34-740 (Super-10), #36-380 (XL-10), and #36-600) as well as Jet #JSL-10TS Shopline. $8 + shipping.
(continued in next post)
First PM that says "I'll take it" gets it. Check or PayPal (buyer covers fees). Shipping is from 22153 (northern Virginia).
1. Stanley/Bell System 2101A 10" brace. Great brace, just a duplicate for me. I've opened this up, cleaned out the old, gummed up grease, and re-lubricated it. Ratcheting mechanism works smoothly. $35 + shipping.
2. Miller Falls 772 10" brace with a Lion chuck. Essentially the same description as above. $35 + shipping.
3. 4" slick/chisel with a socket. Ok, it's actually 3-7/8" wide. About 13" long. "Mallet Cast Steel" is stamped on the top (see picture). The cutting edge is currently dull and has a couple chips that will need to be sharpened out (see picture). Based on my file skating along the cutting edge, it is indeed hardened and there appears to be a faint line (about 1.5" from the edge) where the hardened steel for the edge is welded to a softer steel for the body (I assume), similar to old hand plane blades. Still plenty of life. It looks like someone hit the socket end with a hammer a few times, so that will need to be cleaned up, but it's not horrible. Reasonable pricing on these is really hard to figure out and seems to go up exponentially with the width of the slick. How about $90 + shipping. Let me know if I'm way out of line. I tried to be reasonable based on the info that I could find.
4. Leecraft phenolic zero clearance insert, model DL-2. 3-3/4" x 12-1/2". Fits Delta 10" direct drive (#34-670, #34-740 (Super-10), #36-380 (XL-10), and #36-600) as well as Jet #JSL-10TS Shopline. $8 + shipping.
(continued in next post)