Delta contractor table saw - Spartanburg, SC
#17
That looks like a 34-444 that I had, and it may have the motor that Delta rated at 1.5 HP for 120V, and 2 HP for 240V. In truth it's a 2 HP motor they derated at 120 to meet UL requirements. If that's the case you may still get what you want.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#18
It is indeed the 34-444. Here is a pic with the specs.
Reply
#19
Larger pic. I’ll try and get a pic of the motor plate.
Reply
#20
Looks exactly like my Craftsman 3 hp contractors saw.
John

Always use the right tool for the job.

We need to clean house.
Reply
#21
Two suggestions...one already has been made.

1. Dedicated dado blade setup.

2. Don't laugh but part it out on Ebay.  I have done it and have gotten for more then I could have sold an intact saw for. Fence, rails, stand, crank handles, cast iron top, motor, etc....plus you have a mobile base.
"Life is too short for bad tools.".-- Pedder 7/22/11
Reply
#22
Saw has been sold
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.