Scrollsaw auxiliary table top
#3
  
I made an auxiliary top for my 40-560 Delta scrollsaw. It is held in place by cleats around the original table and on either side of the frame at the back. Rare earth magnets at the rear also help hold it place. The top rocked a bit if the workpiece was large enough to reach the edges. I finally found a solution using a piece of hardware I remember using as a kid when we replaced screen windows on our farmhouse.

Snap Fasteners

They press against the underside of the original table with enough force to keep the table level yet are easy to release when I remove the auxiliary table.

It only took me three years to come up with this solution.

Bill


Attached Files Image(s)
   
   
   
   
Reply
#4
  Re: Scrollsaw auxiliary table top by wjt (I made an auxiliary ...)
Pretty cool nice job.



If it can't kill you it probably ain't no good. Better living through chemicals.

 
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.