07-06-2020, 11:49 AM
I did something similar (but not as pretty, and no drawers). I drilled it like the Festool MFT table top so I can use clamps and dogs. Drilling all those holes was a bit of work. I used a 3/4" drill bushing mounted in a piece of plywood to make sure all were 90 degrees to the table. I used a peg board as a template. First using a Vix bit for the designated hole locations and then following up with a brad point 3/4" drill bit.
I did three tables. On each one I have one hole that is misaligned. I don't know why that is.
I mounted mine on adjustable height feet to get it level with the saw.
I did add some peg board to one side and a 3/4" thick piece of MDF to the other side. I drilled and glued in 1/2" diameter dowels in that side and my blades reside on those dowels.
I was using roller stands but this is an improvement.
Nice work.
I did three tables. On each one I have one hole that is misaligned. I don't know why that is.
I mounted mine on adjustable height feet to get it level with the saw.
I did add some peg board to one side and a 3/4" thick piece of MDF to the other side. I drilled and glued in 1/2" diameter dowels in that side and my blades reside on those dowels.
I was using roller stands but this is an improvement.
Nice work.
No animals were injured or killed in the production of this post.