Makng a bridge setting jig - good idea or not?
#4
  
I don't know how many people make or have made musical instruments here, but I thought I'd post this anyway because it's kind of an interesting (?) jig.

I've been working on a 'contraption' to allow setting the bridge fore and aft, up and down, and side to side. The idea is that once the bridge is properly located, it can be marked and then glued down to the top. For this first prototype test I am using a cigar box uke that I'm making. Hopefully if this works out, the jig will be a little more universal in usage.

So here's my question for you all. Is there something like this already? Is it even necessary? Should I continue on with this project or should I just give up. Bridges have been set since forever, but I will say that after tinkering with setting the various parameters, I felt like it was like, really really in tune.



Reply
#5
  Re: Makng a bridge setting jig - good idea or not? by paulmon (I don't know how man...)
For a pinless bridge, your solution works fine. For a pinned bridge, placement of the saddle is more important than the placement of the bridge, because the saddle determines string length and intonation. Several luthier supply houses have saddle routing rigs. There's even a bridge length calculator on line.

Try places like StewMac or Luthier Supplies to see what's out there.
Still Learning,

Allan Hill
Reply
#6
  Re: Makng a bridge setting jig - good idea or not? by paulmon (I don't know how man...)
I'm working on the next version to deal with these other issue. I hope Smile Thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.