Dewalt 734 snipe after torsion box add on.
#15
After entering the infeed roller, the blades catch the wood wanting to raise the board up, which it will do as the infeed roller acts as a fulcrum.
When the board then enters the outfeed roller, it keeps the board down so the blades cannot pick the board up.
Same when exiting the cutterhead, the outfeed roller again acts as a fulcrum. The weight of the board raises the end and the cutters dig in.

So.....always....*always* slightly lift the board end you are holding when inserting a board, and always raise the end of the board *up* when it is exiting the planer, before it leaves the infeed roller.
Most all planers have this problem.

If I was to engineer a wood planer, it would have double rollers on each end.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#16
(03-01-2021, 06:55 PM)Stwood_ Wrote: After entering the infeed roller, the blades catch the wood wanting to raise the board up, which it will do as the infeed roller acts as a fulcrum.
When the board then enters the outfeed roller, it keeps the board down so the blades cannot pick the board up.
Same when exiting the cutterhead, the outfeed roller again acts as a fulcrum. The weight of the board raises the end and the cutters dig in.

So.....always....*always* slightly lift the board end you are holding when inserting a board, and always raise the end of the board *up* when it is exiting the planer, before it leaves the infeed roller.
Most all planers have this problem.

If I was to engineer a wood planer, it would have double rollers on each end.

Thanks for all the replies.
"Life is too short for bad tools.".-- Pedder 7/22/11
Reply
#17
Easy fix. Stationary planner! 
No snipe is just one of the advantages
I long for the days when Coke was a soft drink, and Black and Decker was a quality tool.
Happiness is a snipe free planer
Reply
#18
(02-22-2021, 10:11 PM)Scott W Wrote: What gives?  I had front and rear snipe before...I added this melamine torsion box and, while the wood slides awesomely now, the snipe is still there.  Front and rear. 

What am I doing wrong?  I know if I use sacrificial stock before and after then I can get rid of it but that requires a degree of athleticism and coordination that I only aspire to.

Suggestions?

I expect it is the cutterhead moving as suggested by Phil.
I had this issue with the ridgid r4330.  It was not addressed by infeed/outfeed support and only helped by feeding the stock sequentially.

I believe the DW734 has a cutterhead lock. Are you using that and still seeing the snipe?
(If you are getting snipe with the lock set, I'd be looking to see if roller pressure can be adjusted to reduce the forces on the board)

Does depth of cut affect the snipe?   Length of workpiece?  Location on table (left/right/center)?

Are your blades sharp?

Matt
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.