Resawing on bandsaw
#24
  Re: Resawing on bandsaw by Rogm1017 (Hello, Have a quest...)
The Grizzly cast iron fence is quite rigid and the locking mechanism is very good, too, but I'm really only using it with my tall fence to keep it parallel with the miter slot. Any fence would work though you might have to clamp the tall fence at both the front and back.
John
Reply
#25
  Re: Resawing on bandsaw by Rogm1017 (Hello, Have a quest...)
Tapper, I went to a lot of trouble to get the perfect fence...not!!!  I simply clamped a board to the table.  I was resawing 8" cedar and I may not be so lucky in hardwood but I will not hesitate to try the idea again.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#26
  Re: RE: Resawing on bandsaw by Bill Holt (Tapper, I went to a ...)
Curious, I just realized the OP never made another comment.  Did we scare him/her off?  

John
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.