How thick glass shelve
#12
(01-12-2022, 01:39 AM)iclark Wrote: How big are you planning to make the V-groove? How are you planning to make the groove?

Unless you have a good way to deal with the microcracks introduced by that machining, I would suggest doing the strength calculation based on the thinnest part of the shelf under that groove.

Even then, it might be a good idea to use 3 brackets/pins on each end. Otherwise, you are putting all of the weight on the pre-cut to shear the shelf.

I don't recall where you are located. If you are in an earthquake zone, then you might want to add some extra safety margin to the strength calculation.

SW Mo. No more earthquake zone than a lot of the country.
Jim
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.