Wipe-on MINWAX
#4
I asked this in Finishing, but there isn't a lot of traffic there.

...is my go-to for finishing on turnings, mostly bowls.  I use paper towels to apply the finish.  As you might guess, even with three coats, a can last a long time.

Problem: the once thin liquid begins to thicken.  I have added paint thinner several times, with little change seen.

Question: once it begins to "jell", should I just give up and buy a new can?
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#5
It’s what I’ve used for years on hundreds of bowls. Once it thickens, it’s done. I’ve tried all kinds of ways to “save” it and none worked well.
VH07V  
Reply
#6
I cannot comment on the MINWAX.

I can say that I used Deft as a wipe-on on my first successful hollow-form (done in a private class). The wood was very highly figured maple and pretty dry. The wood really sucked up the Deft and darkened so much that much of the figure was no longer visible without a close look.
Sigh

That sort of discouraged me from using wipe-on poly after that.
"the most important safety feature on any tool is the one between your ears." - Ken Vick

A wish for you all:  May you keep buying green bananas.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.