10-19-2022, 01:16 AM
(This post was last modified: 10-19-2022, 01:16 AM by lincmercguy.)
I'm starting my stair tread project up again. Obviously, it's easier to finish the treads before installation. However, to match my flooring, I use a couple of treatments of Transtint mixed with distilled water before staining and polyurethane.
My concern is that if I use this on the treads before installation, they will warp. The retrotreads are 5/8" thick. I've tried using Transtint mixed with DNA previously, and it didn't work that well. It's usually very dry here, so it flashed off very quickly.
Any other ideas?
My concern is that if I use this on the treads before installation, they will warp. The retrotreads are 5/8" thick. I've tried using Transtint mixed with DNA previously, and it didn't work that well. It's usually very dry here, so it flashed off very quickly.
Any other ideas?
Project Website Adding new stuff all of the time.