This partly segmented piece finished at 12 1/2" D x 5" tall made from Walnut and Wenge. The piece was first turned on the lathe then the pattern was hand drawn before the carving and pyrography work was done the final finish is lacquer.

Attached Files Image(s)
You've done it again Bruce, awesome work.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Very nice!
What tools did you use for the carving?
As usual a stunning piece. Totally awesome.

I turn, therefore I am!
(11-05-2022, 05:46 AM)Dusty Workshop Wrote: Very nice!
What tools did you use for the carving?

Thank you everyone for the nice complements, most of my carving is done with Flexcut gouges and knives and I also use a 8220 Dremel with small burs.

Forum Jump:

Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.