Posts: 101
Threads: 0
Joined: Jul 2021
Our 20-year-old Delta table saw blows the 20 amp SquareD breaker when we turn it on. It is a dedicated circuit, so it’s not overloaded. Thinking it must be a weak breaker, we replaced it. That didn’t help. The V-belt has been replaced with a link belt, so it’s not a hard spot in the belt.
I opened the motor to check the bearings. One was a bit noisy, so both bearing got relubed. It often still trips the breaker.
Any ideas! Thanks in advance.
Posts: 755
Threads: 0
Joined: Jan 2007
Location: ATL
capacitor is going bad ?
try it on a different circuit to verify.
Posts: 1,992
Threads: 1
Joined: Aug 2016
(04-17-2023, 08:19 PM)Cabinet Monkey Wrote: capacitor is going bad ?
try it on a different circuit to verify.
I will second the capacitor being the problem. Roly
Posts: 101
Threads: 0
Joined: Jul 2021
(04-18-2023, 05:49 AM)Roly Wrote: I will second the capacitor being the problem. Roly
Thank you for this suggestion. Since I don’t know about motors, I wouldn’t have thought of it. I’ll see what happens on a different circuit. —Peter
Posts: 64,589
Threads: 3
Joined: Feb 2007
Location: Merryland
It could also be a weak breaker. Maybe swap it out with another 20 amp breaker to check it.
Posts: 755
Threads: 0
Joined: Jan 2007
Location: ATL
(04-18-2023, 09:08 AM)Snipe Hunter Wrote: It could also be a weak breaker. Maybe swap it out with another 20 amp breaker to check it.
um.....................................see the orig. post
Posts: 1,992
Threads: 1
Joined: Aug 2016
(04-18-2023, 08:40 AM)Petertaylor Wrote: Thank you for this suggestion. Since I don’t know about motors, I wouldn’t have thought of it. I’ll see what happens on a different circuit. —Peter
Look at the capacitor, if it is bulged or leaking it will be bad, but can be bad if it looks normal. 20 years old is suspect for it to be bad. Roly
Posts: 18,490
Threads: 0
Joined: Jul 2008
Location: Free At Last!
04-21-2023, 01:23 AM
(This post was last modified: 04-21-2023, 01:24 AM by lincmercguy.)
(04-18-2023, 06:35 PM)Roly Wrote: Look at the capacitor, if it is bulged or leaking it will be bad, but can be bad if it looks normal. 20 years old is suspect for it to be bad. Roly
I had the same symptoms with a cap that went bad in a Ridgid TS3650 tablesaw. I went through the same troubleshooting, trying different breakers and the issue followed the saw. The cap did not look bulged or discolored. I didn't test it to see if it measured up to the rating but I just shotgunned a new one. I had no issues with the saw for several years after until I sold it.
I hope your issue is a simple and cheap fix like the start capacitor.
