Posts: 4,133
Threads: 2
Joined: Feb 2003
Location: Winston Salem, NC
01-05-2024, 06:12 AM
(This post was last modified: 01-06-2024, 05:59 AM by Rick_B.)
[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Looking for a good spindle with chuck release nut for a pre 1937 Buffalo Forge 15" drill press. If you have something let's talk[/font]
[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Rick[/font]
Rick
Posts: 4,133
Threads: 2
Joined: Feb 2003
Location: Winston Salem, NC
(01-05-2024, 06:12 AM)Rick_B Wrote: [font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Looking for a good spindle with chuck release nut for a pre 1937 Buffalo Forge 15" drill press. If you have something let's talk[/font]
[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Rick[/font]
So a few specifics - doesn't have to be a Buffalo spindle. It does need to be a6 spline, 5/8" diameter, at least 15" long with a spline length of at lease 6-1/2" and a taper chuck fitting.
Rick
Rick
