Posts: 121
Threads: 0
Joined: Sep 2019
Finishing a black walnut natural edge bowl. This bowl was roughed out years ago and sat on a shelf because the mortise warped too badly for the chuck to grab it to final turn. After gluing on a waste block and finish turning, it was sanded to 600 grit, Myland's sanding sealer applied and finished with acrylic enamel.
Posts: 27,841
Threads: 0
Joined: Jul 2002
Location: Pacific ocean now much further away!
07-31-2024, 12:48 PM
(This post was last modified: 07-31-2024, 12:51 PM by EightFingers.)
Did a lot of those type bowls, in fact near the end those were the only ones I turned because they sold so well. I didn’t like sanding the “wings”, lot of finesse to get it just right.
I would put a bow tie patch over the cracks.
VH07V