Oil based wiping cut of Poly over nitrocellulos lacquer
#4
I'm finally getting around to trying to fix a table top that had water damage (my bride put some jugs of water on top to prep before a hurricane, and they leaked).

Question is, has anyone put a wiping cut (50-50 oilbased poly and MS) over a nitro finish?  I'm thinking of evening out the flaked portions of the  nitro with acetone, and then hiting it with 400 grit (or OOOO steel wool) to rough it up, then wiping on the cut poly.  Any advice is welcome.
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Reply
#5
(09-26-2024, 06:10 PM)Admiral Wrote: I'm finally getting around to trying to fix a table top that had water damage (my bride put some jugs of water on top to prep before a hurricane, and they leaked).

Question is, has anyone put a wiping cut (50-50 oilbased poly and MS) over a nitro finish?  I'm thinking of evening out the flaked portions of the  nitro with acetone, and then hiting it with 400 grit (or OOOO steel wool) to rough it up, then wiping on the cut poly.  Any advice is welcome.

I've never done what you propose, but I'd think about spraying a coat of dewaxed shellac over the lacquer before wiping on the poly mix.  

John
Reply
#6
(09-26-2024, 07:10 PM)jteneyck Wrote: I've never done what you propose, but I'd think about spraying a coat of dewaxed shellac over the lacquer before wiping on the poly mix.  

John

Thanks, I’ve seen that mentioned in the guitar forums, they deal with nitro a lot.
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.