RAS Miter Table

[jteneyck]

I posted about a new RAS Miter Table up in the Woodworking section.  Link  



It's 32 x 17" and fits most any RAS.  The unit is made from 3/4" plywood and comes with the hardware needed to install it on your RAS.  I make it on my CNC, so tolerances are very tight.  You will need to drill 4 holes in your table, one for the 1/4" pivot, one for the table lock, and two for the fine adjustment bracket. Installation takes less than 30 minutes.  Removing and reinstalling the miter table is done in less than 1 minute.  

The unit costs $95 (PayPal or check) and includes shipping within the CONUS.  Shipment is about 1 week.  

John

[Tapper]

FWIW, I've known John on this board for several years now. We've done some business in the past (I have one of his mortising machines, which works nicely as advertised) and his work is always impeccable.

I also have a Dewalt GA medium arm RAS that I'm nearing completion of a refurbishment on and ordered the miter table yesterday. Being able to leave the blade at dead 90 degrees and cut accurate miters can only be an advantage IMO.

I have no financial or other interest in this endeavor whatsoever.

Doug