This partly segmented piece finished at 12 1/2" D x 5" tall made from Walnut and Wenge. The piece was first turned on the lathe then the pattern was hand drawn before the carving and pyrography work was done the final finish is lacquer.
You've done it again Bruce, awesome work.
Very nice!
What tools did you use for the carving?
As usual a stunning piece. Totally awesome.
(11-05-2022, 05:46 AM)Dusty Workshop Wrote: [ -> ]Very nice!
What tools did you use for the carving?
Thank you everyone for the nice complements, most of my carving is done with Flexcut gouges and knives and I also use a 8220 Dremel with small burs.