Woodnet Forums
Carbide woodturning tools please see new thread - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Carbide woodturning tools please see new thread (/showthread.php?tid=7323512)

Pages: 1 2 3 4 5


RE: Carbide woodturning tools - Bob10 - 11-07-2016

you are on the wrong page if you are looking there.  You need to be on the page with the list of forums below


RE: Carbide woodturning tools - Herb - 11-07-2016

I went to questions about woodnet forum and was advised to click on my CP, but for the life of me, I see not cp.
Confused


RE: Carbide woodturning tools - iclark - 11-07-2016

On this page (the one where you are reading my reply) at the top left and just below "Welcome" should be a link for "UserCP"

Click on that "UserCP" and then follow the configuration instructions earlier in the thread.

If "UserCP" is not there, then you might be set to use one of the mobile display forum interfaces. There is a way to toggle that, but I do not remember how to do it.

Report back and one of the mobile interface guys can help you if that is the problem.


RE: Carbide woodturning tools - jaustin - 11-08-2016

Herb,
 I attached a picture of the main page showing the "user cp", it's located under welcome back

IF you can't get it to work my email is gotome2@yahoo.com


John


RE: Carbide woodturning tools - Herb - 11-08-2016

No, it is not there.  I do not see "user cp".  I have posted on the sites to ask questions, but so far nothing has helped.  I sent a request through "contact".

Thank you for your help!!


RE: Carbide woodturning tools - fgarvin - 11-08-2016

Herb

Try clicking this:

https://forums.woodnet.net/usercp.php

If you're logged in, it should take you to the User CP


RE: Carbide woodturning tools - Herb - 11-08-2016

I sent you a PM so I hope you get it. I do not know how I will know if I receive a pm.  You may email me at herbwofford@gmail.com.

Thank you


RE: Carbide woodturning tools - Herb - 11-08-2016

Fgarvin, how do I thank you!  I did get to my page and hopefully you will get my PM, If I did things correctly.  I still do not cp under my login information.  Hopefully I can see when someone sends me a PM.

Again, you and Justin are so kind in giving me help.

Thank you,


RE: Carbide woodturning tools - fgarvin - 11-08-2016

Received your Private Message and replied.


RE: Carbide woodturning tools - Herb - 11-08-2016

The only way I knew  you send me a pm is that I received an email.  There was nothing, when I logged in to indicate you had sent me a PM.  

Thank you again.