Rockwell 10 blade raises too high

Rockwell 10 blade raises too high - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Rockwell 10 blade raises too high (/showthread.php?tid=7333202)

Pages: 1 2

RE: Rockwell 10 blade raises too high - Scott W - 09-14-2017

(09-13-2017, 10:34 PM)daddo Wrote: Fit a block of wood to stop the arbor at the right height then epoxy it to the underside.

This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work.

Thanks all

RE: Rockwell 10 blade raises too high - daddo - 09-14-2017

(09-14-2017, 05:42 AM)Scott W Wrote: This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work.

Thanks all

Use accurate wood.
Wink

If the cast top is thick enough, you can drill and tap a hole to accept a 1/4" screw through the top and above the arbor. It would have to be counter sunk.