Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
(09-13-2017, 10:34 PM)daddo Wrote: Fit a block of wood to stop the arbor at the right height then epoxy it to the underside.
This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work.
Thanks all
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
09-14-2017, 07:23 AM
(This post was last modified: 09-14-2017, 07:27 AM by daddo.)
(09-14-2017, 05:42 AM)Scott W Wrote: This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work.
Thanks all
Use accurate wood.
If the cast top is thick enough, you can drill and tap a hole to accept a 1/4" screw through the top and above the arbor. It would have to be counter sunk.
