+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Advice needed on legs--Updated with pics-- (/showthread.php?tid=7344322)
RE: Advice needed on legs--Updated with pics-- - Tapper - 12-31-2018
Ya done good!
Doug
RE: Advice needed on legs--Updated with pics-- - camp10 - 12-31-2018
Good looking table.
How did you get that bevel on the top piece? Especially on the end grain sides.
RE: Advice needed on legs--Updated with pics-- - shoottmx - 12-31-2018
(12-31-2018, 08:18 AM)camp10 Wrote: Good looking table.
How did you get that bevel on the top piece? Especially on the end grain sides.
Thanks everyone. The bevels were cut on the table saw with the blade angled about 20*. I made an auxillary fence about 18" high out of MDF and bolted it to the face of my Incra TSLS. I added feather boards both infeed and outfeed. I was careful to feed at an even rate but cutting the bevels was quick and easy.
g
RE: Advice needed on legs--Updated with pics-- - Hank Knight - 01-01-2019
That turned out nice! I like it a lot better than your earlier pic. Your wife has a good eye.