Woodnet Forums
circular saw cutting guide - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: circular saw cutting guide (/showthread.php?tid=7322964)

Pages: 1 2 3 4


RE: circular saw cutting guide - Cecil - 10-06-2016

(10-06-2016, 09:53 AM)bennybmn Wrote: That's a good point right there. A little overhang is fine as long as you cheat it so that nothing will fall once the cut is complete.

I also don't like spring clamps because they can shift...

I never had a spring clamp shift when using a guide like in the OP.  In this case, part of the guide is under the saw.  I have had clamps shift when clamping a straight edge as a fence only.  Stability is something to be aware of, so you do make a great point.