+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Bowl 'Stitching' Technique (/showthread.php?tid=7006074)
Bowl 'Stitching' Technique - badwhiskey - 04-30-2015
Jerry Kermode has a technique for using a biscuit joiner to cut slots, and then glue in 'stitches' to correct for cracks and defects in bowl blanks. Here's an example:
Does anyone know the details of how to do this? I've been messing around, but I don't think I have right.
Re: Bowl 'Stitching' Technique - Wipedout - 04-30-2015
Are you doing it and then finish turning?
Re: Bowl 'Stitching' Technique - badwhiskey - 05-01-2015
I haven't done it yet, but yes. My thought is, mostly turn it down, cut the slot. But the slot has ends at an angle that I can't see, just wondering how to cut the pieces for the 'stiches' so I get a good fit.
Re: Bowl 'Stitching' Technique - Souperchicken - 05-01-2015
If you shape your inserts with a radius the same as the cutter on the tool they will fit perfectly, right?
Re: Bowl 'Stitching' Technique - cams2705 - 05-01-2015
After you partially turn down the blank and cut the initial slots with the biscuit joiner, I would think that you would have to square the ends of the cuts with a chisel (1/8" most likely matches the thickness of that blade) so the insert will fit snugly. Then finish turning.
Re: Bowl 'Stitching' Technique - badwhiskey - 05-01-2015
cams2705 said:
After I would think that you would have to square the ends of the cuts with a chisel (1/8" most likely matches the thickness of that blade) so the insert will fit snugly.
Yeah, I think that's the step I'm missing. I'll play with that idea. Thanks.
Re: Bowl 'Stitching' Technique - chips ahoy - 05-01-2015
Frank
What do you use for the lace, ebony?
Mel
Re: Bowl 'Stitching' Technique - Arlin Eastman - 05-01-2015
I like the affects and I to am wondering how it was done.
Arlin
Re: Bowl 'Stitching' Technique - badwhiskey - 05-01-2015
I've just been playing. I'd probably use walnut.
Re: Bowl 'Stitching' Technique - handi - 05-02-2015
It's a cool technique.
Biscuit cutter blades are, IIRC, 0.80 inches thick or there about, so I do not think a 1/8" chisel will work. That being said, I might try to make my own biscuit shaped bits to fill the biscuit slot. Should not be that hard to plane stock down until it is snug in the slot, them make a template of a biscuit and shape plugs to match the slots. No need to make them full ovals, just cut a strip as wide as a biscuit, round the end, cut it off, round the end, cut it off, rinse and repeat.
Glue the plugs in place then finish turning.
Ralph