Cleaning Airless Sprayer Hose - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Cleaning Airless Sprayer Hose (/showthread.php?tid=7067767) |
Cleaning Airless Sprayer Hose - Bill Bob - 08-03-2015 I posted this in the Finishing Forum with no answers. Maybe it will be viewed by more here? this is the post. I have always used latex material not a problem cleaning it all. However what is a good way to clean the 50 foot long hose when finished with enamel type paints? Just the hose alone holds a quart of fluid. Seems like it may take a gallon or two of thinner to flush it out completely if not more? Bill Re: Cleaning Airless Sprayer Hose - John Mihich - 08-03-2015 I don't know any other way then to run the cleaner through. I would take a couple of quarts and let it recycle for quite some time. Take 2 more quarts of clean stuff and run it through. I'm I would probably run another 2 quarts after that. I've never used oil in mine so I'm just guessing based on latex cleaning. I go overboard cleaning my hose. I didn't do it right once and I had to replace it. Re: Cleaning Airless Sprayer Hose - Bill Bob - 08-03-2015 Thanks John Sounds like a good plan to me on running it thru several times. Based on that I think I will just use latex always. Thanks, Bill Re: Cleaning Airless Sprayer Hose - Estrogen Hostage - 08-03-2015 Thinner, then leave it in the hose when you store it. Re: Cleaning Airless Sprayer Hose - jteneyck - 08-03-2015 Hasn't some clever company developed a hose pig that you can push through with compressed air? If not, here's your chance for fame and fortune. But here's a company that may have what you need. Link John Re: Cleaning Airless Sprayer Hose - K. L. McReynolds - 08-03-2015 Back when I used oil based finishes, I had a system. I had three types of thinner for cleaning. I kept each type in old gallon bottles(the plastic ones new thinner comes in) and labeled them 1, 2, and 3. I wound up with more #3 bottles because of the system. And even had bottles marked Old #3 and New #3. To clean a brush(or sprayer), I used some of the decanted #3---letting it set for about 3 weeks caused most of the solids to sink to the bottom of the bottle. That left a partially diluted solution(usually yellow) which still had plenty of thinner capabilities. I would empty that amount into another #3 bottle marked Old 3. Then I would use a #2 bottle which had only one use thinner in it. That would get most of the finish out of a brush and most out of a sprayer. That mixture got emptied into a New#3 bottle. Then I used a small amount of new thinner and finished up just blowing the thinner out of the sprayer or a wash with Dawn on the brushes. I have Purdy brushes that are 30 years old, still like new. I seldom bought thinner much after getting that system working. Had about 9-10 gallon bottles for the thinner, tho. Re: Cleaning Airless Sprayer Hose - John Mihich - 08-04-2015 Yes about used thinner. If you let it sit the paint will settle to the bottom. Cleaning those hoses is really important. I think if I ever started using my airless sprayer for oil I would buy another hose. I know my brother uses his system only with oil. If I have a chance I'll ask him about cleaning. Re: Cleaning Airless Sprayer Hose - Bill Bob - 08-04-2015 Thanks John Don't bother. I have decided to only use latex only. Thanks for your help Regards, Bill |