Looking for Mark/ “The little jig that could” - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Looking for Mark/ “The little jig that could” (/showthread.php?tid=7120386) |
Looking for Mark/ “The little jig that could” - fall - 10-15-2015 I am looking for Mark M that used to visit the sawmill form and made “The little jig that could” It’s a router jig that he made back in about 2006. (I not good at posting pictures on this forum from the web) If you do a web search with the title and form you will see what I am talking about. (I don’t think I am suppose to post there link) any way I was told he is a member here and would love to get some information and or plans for the jig. Any help would be appreciated or if you’re out there Mark? Thanks Re: Looking for Mark/ “The little jig that could” - FBranco - 10-15-2015 Mark hasn't been around for years Re: Looking for Mark/ “The little jig that could” - Doug_H - 10-15-2015 Mark has an active post on sawmill creek as I write this, and the title of the post is the little jig that could. Doug Re: Looking for Mark/ “The little jig that could” - cvillewood - 10-15-2015 The OP here brought that thread back from the dead to try and find Mark, I think. Re: Looking for Mark/ “The little jig that could” - fall - 10-15-2015 cvillewood said: You are correct that was me. To bad he has not been around. I would love to try to get one of these jigs somehow... Richard |