+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Thrust bearing replacement delta 14"bandsaw?H (/showthread.php?tid=7212336)
Thrust bearing replacement delta 14"bandsaw?H - Bill Mains - 02-05-2016
Have model 28-255 and cannot figure out how to remove lower thrust bearing. Have removed screw on rod holding shaft that holds bearing but not enough room to slide shaft all the way forward. Any tips? Thanks...Bill
Re: Thrust bearing replacement delta 14"bandsaw?H - mike4244 - 02-05-2016
Do you have a 3 jaw puller?Should pull off fairly easy.
mike
Re: Thrust bearing replacement delta 14"bandsaw?H - Bill Mains - 02-05-2016
It's not stuck on shaft. The problem is lack of room to remove shaft n bearing.
Re: Thrust bearing replacement delta 14"bandsaw?H - Axl - 02-05-2016
Take the whole assembly apart. Good time to clean it. 2 large screws hold it to the table bracket.
Re: Thrust bearing replacement delta 14"bandsaw?H - Bill Mains - 02-06-2016
Got it done. Found best to remove table which gave much better access.