Posts: 440
Threads: 0
Joined: Oct 2003
Have model 28-255 and cannot figure out how to remove lower thrust bearing. Have removed screw on rod holding shaft that holds bearing but not enough room to slide shaft all the way forward. Any tips? Thanks...Bill
Posts: 4,452
Threads: 0
Joined: Jan 2005
Do you have a 3 jaw puller?Should pull off fairly easy.
mike
Posts: 440
Threads: 0
Joined: Oct 2003
It's not stuck on shaft. The problem is lack of room to remove shaft n bearing.
Posts: 1,430
Threads: 1
Joined: Jun 2008
Take the whole assembly apart. Good time to clean it. 2 large screws hold it to the table bracket.
Posts: 440
Threads: 0
Joined: Oct 2003
Got it done. Found best to remove table which gave much better access.
