+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Tailpiece of vessel sinks was made out of stainless, not brass (/showthread.php?tid=7256484)
Tailpiece of vessel sinks was made out of stainless, not brass - Wild Turkey - 04-01-2016
Only cost me a good miter saw blade and four stitches to learn that
Re: Tailpiece of vessel sinks was made out of stainless, not brass - Robert Adams - 04-01-2016
Eww not fun. I always cut those with a bandsaw or hacksaw.
Re: Tailpiece of vessel sinks was made out of stainless, not brass - Anak - 04-01-2016
Ouch.
I found one of those with a tubing cutter. Not nearly as bad as your experience, just much harder work.
Re: Tailpiece of vessel sinks was made out of stainless, not brass - museumguy - 04-02-2016
Yikes !! Hope it wasn't too serious and you heal quickly. On a much smaller scale, I cut some screws off the other day, betting they were stainless. Nope, nickel plated brass. You just never know.