+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Making a Top for Router Table (/showthread.php?tid=7327965)
Pages:
1
2
Making a Top for Router Table - Halfathumb - 02-15-2017
Got a new lift so I had to make a new table top. Carefully measured for the 2 router jigs. Perfect! Routed the inner cut to make the hole for the lift to fit through. Perfect! Placed the new top on the cabinet. Not really good! I cut the hole in the wrong direction. Crap! Now I'll have to make a new fence and the switch is now on the back.
Oh well. Things could have gone worse I guess. Just make adjustments to the situation.
RE: Making a Top for Router Table - Wild Turkey - 02-15-2017
BTDT
RE: Making a Top for Router Table - Cecil - 02-15-2017
Can't you just mount it upside down and use the router from the bottom?
RE: Making a Top for Router Table - Stwood_ - 02-15-2017
Well you need to post a pic so we can *tell* you its wrong.
Oh I hate those blunders. Sorry it happened to ya.
RE: Making a Top for Router Table - Halfathumb - 02-17-2017
I'm to embarrassed to post a pic. Plus I tried to salvage it and just made matters worse. Another addition to the wood pile.
RE: Making a Top for Router Table - Halfathumb - 02-17-2017
Okay. What does BTDT stand for?
RE: Making a Top for Router Table - s9plus20 - 02-17-2017
(02-17-2017, 07:44 AM)Halfathumb Wrote: Okay. What does BTDT stand for?
Been There Done That
RE: Making a Top for Router Table - Steve N - 02-17-2017
Sorry it happened, but remember measure twice, cut once isn't just for TS cuts. A trial fitting would have probably pointed out what was going to happen. Hope you can make it work.
RE: Making a Top for Router Table - daddo - 02-17-2017
Sell it to someone you don't like and make another.
RE: Making a Top for Router Table - rwe2156 - 02-20-2017
Make sure you laminate both sides of that top!