+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: My first segmented turning is a funnel (/showthread.php?tid=7328595)
My first segmented turning is a funnel - SceneryMaker - 03-09-2017
on purpose. I wanted to make a vase for cut flowers but it had to be wood. Since I'm not even good enough to finish the outside of a piece of wood to be really watertight (don't even think about getting the inside watertight), I had to do something different.
I made the bottom open so I could put a 1-3/4" diameter by 7-1/2" tall glass vase inside. the top was just small enough to hide the lip of the vase so if you try to peek inside, all you see is the smooth glass vase and it seems to have a great finish. Sneaky, huh?
No pics, didn't happen, so I attached one.
I used my new Wedgie sled to cut up a plain old pine 1x4, then dyed it with Rit dye after turning. The finish is Eddie Castelin's Shine Juice (equal parts BLO, clear shellac, and DNA).
For a first effort, I like it.
RE: My first segmented turning is a funnel - Arlin Eastman - 03-09-2017
I like it too.
Just wondering on the waterproofing is it possible to take epoxy and put enough in the vase and roll it around so it covers all the areas and then let it dry?
Or finish it in stages and put the epoxy in the inside at each stage?
RE: My first segmented turning is a funnel - Turner52 - 03-09-2017
Nice job and a great project for a first segmented turning
RE: My first segmented turning is a funnel - chips ahoy - 03-09-2017
That is a beautiful piece of work,very well done.
Mel
RE: My first segmented turning is a funnel - iclark - 03-10-2017
SM: very nicely done! I like it.
Arlin: I do not know of any epoxies that are waterproof. There may be some, but the ones that I know about let water diffuse through them.
RE: My first segmented turning is a funnel - Herb G - 03-10-2017
If you want a waterproof interior, think fiberglass resin.
The stuff they build boats from.
Any marine supply house will carry it.
RE: My first segmented turning is a funnel - badwhiskey - 03-10-2017
I like it. There are glass inserts for vases. Personally, I wouldn't trust a watertight wood finish for a vase. I've seen some at craft shows, and they were done with epoxy, but I don't think its a permanent, no-maintenance solution.
RE: My first segmented turning is a funnel - MichaelMouse - 03-10-2017
There are some so devious that they make light, thin, closed forms with 3/8 holes up top, and cleverly concealed taper plugs cut from, then reinserted in, the bottom. No me, of course, but some folks.
I use inserts. As a note, if the wood isn't fully cured, it will contract and grab the insert. Make the hole a bit size larger so you can remove and fill the insert.