Delta cast iron table saw wing wanted - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Delta cast iron table saw wing wanted (/showthread.php?tid=7329955) |
Delta cast iron table saw wing wanted - dallas - 05-02-2017 Have Delta Contractor saw purchased in 1987 (model 34-444 or 445); has a table extension on the right side with a Unifence. Love the saw - would like to replace the stamped steel wing on the left side with a cast iron wing.....does anyone have suggestions where I can find one? Thanks. RE: Delta cast iron table saw wing wanted - texaswally - 05-02-2017 Ebay: http://www.ebay.com/itm/9-DELTA-TABLE-SAW-CAST-IRON-EXTENSIONS-WITH-SPECKLED-PAINT-TAB-140-/282451980393?hash=item41c3733069:g:DQEAAOSwIWVY-raE RE: Delta cast iron table saw wing wanted - Bob Vaughan - 05-02-2017 Look for 9x27" Unisaw extension wings. The Unisaw extension wings also fit the various 10" contractor saws of that vintage. Those linked above are for a 9" saw. RE: Delta cast iron table saw wing wanted - JDuke - 05-02-2017 Something else to think about, back when my only saw was a craftsman contractor saw (same 27" deep table as yours I was able to pick up a second saw for about $100 and bolted the two together for a larger work surface and it was nice to have a place to always have a dado setup. Duke RE: Delta cast iron table saw wing wanted - Lynden - 05-03-2017 Instead of buying a Delta wing, you could put the money toward a cast iron router wing. http://www.ptreeusa.com/tablesaw_router_wing.html http://www.homedepot.com/p/General-International-Excalibur-16-in-x-27-in-Cast-Iron-Table-40-070/205414495 |