|
Delta cast iron table saw wing wanted
|
05-02-2017, 03:52 PM
Have Delta Contractor saw purchased in 1987 (model 34-444 or 445); has a table extension on the right side with a Unifence. Love the saw - would like to replace the stamped steel wing on the left side with a cast iron wing.....does anyone have suggestions where I can find one? Thanks.
05-02-2017, 04:02 PM
Doing it right cost less than doing it over
05-02-2017, 05:15 PM
Look for 9x27" Unisaw extension wings. The Unisaw extension wings also fit the various 10" contractor saws of that vintage. Those linked above are for a 9" saw.
05-02-2017, 07:00 PM
Something else to think about, back when my only saw was a craftsman contractor saw (same 27" deep table as yours I was able to pick up a second saw for about $100 and bolted the two together for a larger work surface and it was nice to have a place to always have a dado setup.
Duke
05-03-2017, 09:41 PM
Instead of buying a Delta wing, you could put the money toward a cast iron router wing.
http://www.ptreeusa.com/tablesaw_router_wing.html http://www.homedepot.com/p/General-Inter.../205414495 |
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
