+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Rolling Table with Rackmount HW (/showthread.php?tid=7335406)
Rolling Table with Rackmount HW - Gary™ - 12-09-2017
I need to build a table-like rolling unit for a new sound board for my church. It needs the capability to install a few rack mount units under it.
Does anybody have a good source for the rack mount hardware?
Or references to designs for units like this?
RE: Rolling Table with Rackmount HW - Gary G™ - 12-09-2017
PC Connection might have what you need.
Darryl Masterson is one of their reps.
Great guy; woodworker, and segmenting woodturner.
RE: Rolling Table with Rackmount HW - EricU - 12-10-2017
I drilled my own rack mount rails. Not much else is really needed. Made it from 3/16" aluminum angle. Tapped the holes with a 10-32 tap held in a hand drill. You can buy just the rails and hardware from music suppliers. I used to get a lot of rack mount stuff from surplus dealers, but I haven't been doing that in a long time, so don't know the current state of supply.