Posts: 33,059
Threads: 1
Joined: May 2004
Location: Hekawi Indian Reservation near Ft Courage
I need to build a table-like rolling unit for a new sound board for my church. It needs the capability to install a few rack mount units under it.
Does anybody have a good source for the rack mount hardware?
Or references to designs for units like this?
Aliens haven't contacted Earth because there's no sign of intelligence here
Posts: 20,903
Threads: 0
Joined: Oct 2003
PC Connection might have what you need.
Darryl Masterson is one of their reps.
Great guy; woodworker, and segmenting woodturner.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Posts: 5,651
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I drilled my own rack mount rails. Not much else is really needed. Made it from 3/16" aluminum angle. Tapped the holes with a 10-32 tap held in a hand drill. You can buy just the rails and hardware from music suppliers. I used to get a lot of rack mount stuff from surplus dealers, but I haven't been doing that in a long time, so don't know the current state of supply.
