+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: WTB 9/16” ID 2 3/4 Pulley for 4” Delta Jointer (/showthread.php?tid=7345370)
WTB 9/16” ID 2 3/4 Pulley for 4” Delta Jointer - Loggerhead - 12-31-2018
Greetings All,
Coming off my long hiatus and getting my hands dirty again. I’m in search of a pulley for a 4” Delta Homecraft jointer, 1954 vintage (S/N: BA 4111). Pulley needed is a 2 3/4” pulley with an ID of 9/16”, non-keyed. Cutterhead arbor has a flat for a set screw.
Any chance someone has one to get rid off?
Carl
RE: WTB 9/16” ID 2 3/4 Pulley for 4” Delta Jointer - Wild Turkey - 01-01-2019
McMaster Carr has a 2-3/4" pulley but only 1/2" or 5/8" shaft. https://www.mcmaster.com/v-belt-pulleys
Since it's "non-keyed" could you use a bushing or get it bored out to fit?
Watch Ebay -- didn't find any today but who knows.
Sweet little jointers -- had one until I got a good deal on an 8"
Good luck!
RE: WTB 9/16” ID 2 3/4 Pulley for 4” Delta Jointer - Loggerhead - 01-01-2019
McMaster and Grainger are the first places I checked and I saw the6 only had the more common bores. Luckily one came up on eBay today, which I was lucky enough to pick up. I’m good to go.