+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Lathe Dust Hood (/showthread.php?tid=7346317)
Lathe Dust Hood - wjt - 02-08-2019
A simple dust collection hood for my mini lathe.
I was looking for a method to support the dust hood and came across a heavy duty gooseneck from SnakeClamp Products. I ordered an 18" version along with a companion 12" rigid extension. The two pieces securely support the dust hood and can be adjusted for easy positioning of the hood. The rigid extension is held by a simple two piece wooden block. The upper section has a split colllar and the lower section is clamped to the lathe tool stand.
The 4" dust collection hose needed extra support so I set in on a Ridgid folding stand from Home Depot. The hose is secured to the stand with a high tech clamp made from strips of an old T-shirt.
A piece of acrylic is attached to the bottom lip of the plastic dust hood which aids in directing chips into the hose.
Thanks for looking.
Bill
RE: Lathe Dust Hood - Souperchicken - 02-16-2019
Looks great, good idea with the folding stand too, those are pretty sturdy.
RE: Lathe Dust Hood - Arlin Eastman - 02-16-2019
It sure looks like it is a great set up for your lathe.
How do you like PSI's new sand paper holder? It looks convenient.
