+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Looking for 1/16" bandsaw blade. (/showthread.php?tid=7348619)
Pages:
1
2
Looking for 1/16" bandsaw blade. - Chuck Nickerson - 06-05-2019
Any leads for me?
RE: Looking for 1/16" bandsaw blade. - woodhead - 06-05-2019
(06-05-2019, 12:08 PM)Chuck Nickerson Wrote: Any leads for me?
Olsen makes a few, but most companies start at 1/8"
Al
RE: Looking for 1/16" bandsaw blade. - Mr Eddie - 06-05-2019
(06-05-2019, 12:52 PM)woodhead Wrote: Olsen makes a few, but most companies start at 1/8"
Al
What width?
Lonnie
RE: Looking for 1/16" bandsaw blade. - bandsaw - 06-06-2019
I have one - got it at Highland Hardware
Guy used to demonstrate boxes and log castles on youtube - said he used a 1/16 inch blade
It's a little bigger than 1/16 not counting teeth
RE: Looking for 1/16" bandsaw blade. - bandsaw - 06-06-2019
I happened to be in Atlanta so picked one up
Then went home and bought a bigger bandsaw
Never used it
RE: Looking for 1/16" bandsaw blade. - Alan S - 06-08-2019
A decade or two ago, after reading Duginske's bandsaw book, I looked for a 1/16" blade. At that time there were still references to which company had made them (Starrett? Lenox?) but they had been discontinued and were no longer for sale.
RE: Looking for 1/16" bandsaw blade. - bandsaw - 06-08-2019
I still have the 1/16th blade - never used - sized for Delta 14" saw
I recently moved my shop and it's in a box somewhere - I can find it
I can mail it - I'm in Canada
RE: Looking for 1/16" bandsaw blade. - Arlin Eastman - 06-09-2019
Glad you made the post. I was looking for one so we could use it for bandsaw boxes.
RE: Looking for 1/16" bandsaw blade. - Alan S - 06-12-2019
(06-09-2019, 12:30 PM)Arlin Eastman Wrote: Glad you made the post. I was looking for one so we could use it for bandsaw boxes.
I would have thought a 1/8" blade would be sufficient for bandsaw boxes, even with quite tight curves. The 1/16" blade is of particular use for fitting sideways into a tablesaw kerf, for instance to cut dovetail baselines in one pass.
RE: Looking for 1/16" bandsaw blade. - Arlin Eastman - 06-12-2019
(06-12-2019, 09:50 AM)Alan S Wrote: I would have thought a 1/8" blade would be sufficient for bandsaw boxes, even with quite tight curves. The 1/16" blade is of particular use for fitting sideways into a tablesaw kerf, for instance to cut dovetail baselines in one pass.
For that to. Well hopefully.
