+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: up grading saw guides (/showthread.php?tid=7353643)
up grading saw guides - tablesawtom - 03-17-2020
I up graded the stock guides on my Mini max S45 band saw from this. The lower guide system has plastic blocks.
[attachment=24969]
[attachment=24970]
To a Carted ball bearing system. The upper guides worked perfectly but I didn't have a clue how the mount what they considered their bottom guide system. And no instructions as to how to install what they sent me.
to make matters worse I only had this much room to work with.
[attachment=24973]
and after a couple trial and errors,
[attachment=24974]
This is what I finally came up with.
[attachment=24975]
[attachment=24976]
[attachment=24977]
I did have to open the hole in the frame for the lower thrust bearing to move it back a little with a cut off wheel on a dremel tool and I had to use a right angled 4 1/2 disc grinder or a support rib on the table.
[attachment=24978]
Anyway what I know have preforms beautifully and I couldn't be happier with it. I have already started on building rip fence for it.
I hope you enjoyed the read.
Tom
.
RE: up grading saw guides - Stwood_ - 03-17-2020
Odd. My MM has the same guides upper and lower.
RE: up grading saw guides - tablesawtom - 03-17-2020
(03-17-2020, 04:06 PM)Stwood_ Wrote: Odd. My MM has the same guides upper and lower.
Is yours a S45? My first two pictures are the original guides from the saw.
RE: up grading saw guides - Stwood_ - 03-17-2020
No, just MM16.......
RE: up grading saw guides - tablesawtom - 03-17-2020
(03-17-2020, 04:46 PM)Stwood_ Wrote: No, just MM16.......
While mine is a Minni Max, it is an S45 and not a 16. There is a big difference between the two, cost being one factor. The other noticeable factor is like having a pick up truck versus a 10 ton dump truck. Both are trucks but they were mot created equal.