+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: A first for me (/showthread.php?tid=7354872)
Pages:
1
2
A first for me - Turner52 - 04-27-2020
This morning I installed a link blade on my table saw. Turned it on and saw sparks fly I must have inadvertently moved the cord running from the switch to the motor. Yes. Cut it right in half. I have cut a couple of cords off skill saws in the past. When you are a carpenter and make hundreds of cuts per day that is bound to happen. Never heard of anyone doing it on a table saw though.
RE: A first for me - fredhargis - 04-27-2020
You have discovered a mistake I haven't made (yet).
I thought I had done them all.
RE: A first for me - Turner52 - 04-28-2020
Apparently I am a genius when it comes to a new way to mess up. It was so dumb I almost had to laugh at myself
RE: A first for me - GeeDub - 04-28-2020
Oh great . . . and just when I thought I had run out of goofs to make
RE: A first for me - TomFromStLouis - 04-30-2020
What is a link blade?
RE: A first for me - stav - 04-30-2020
Probably a link belt.
RE: A first for me - Turner52 - 04-30-2020
Yes ment to say link belt. Can;t even get that right
RE: A first for me - barryvabeach - 04-30-2020
Look at it this way, within a few seconds of installing a link belt, you reduced the vibration so much, you could not even tell it was on.
RE: A first for me - stav - 04-30-2020
Once you learn all the things not to do, you will be an expert tool user.
RE: A first for me - Halfathumb - 05-01-2020
At least it wasn't a thumb.