+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Small parts hvllp spray gun (/showthread.php?tid=7362316)
Small parts hvllp spray gun - mike9 - 04-18-2021
I was looking at adding a smaller sprayer to my fuji mini mite 4 turbine. I see fuji makes a touch up gun but wanted to know if there were other recommendations or has any one tried the fuji. I need the sprayer to work with a turbine not a compressor setup. Thank you.
RE: Small parts hvllp spray gun - Cooler - 04-20-2021
Paasche makes an airbrush for HVLP sprayers. I have not used it though. Paasche is probably the biggest name in the airbrush industry.
The only small parts I spray are screw heads. For that I get a sheet of corrugated cardboard and I poke holes in the cardboard and screw the screws into the sheet of cardboard leaving about 1/8" space between the head and the cardboard.
Then I spray the sheet and all the heads get painted at one time. I leave them in the cardboard until I am ready to drive the screws in.
RE: Small parts hvllp spray gun - mike9 - 04-20-2021
Thank you for the reply. I will have to check them out. I don't need to spray anything that small lol. I am looking to spray 3D printed parts.