Woodnet Forums
LET THERE BE DRAGONS - Printable Version

+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: LET THERE BE DRAGONS (/showthread.php?tid=7371811)

Pages: 1 2 3


LET THERE BE DRAGONS - Splinterz25 - 01-04-2023

LET THERE BE DRAGONS

Okay everyone the drawings are complete. These are only pencil guide lines for the carving and more detail will be added while carving. This will be a combo of piercing and 3-D carving and there will be coloring added, I'll go into that later. This is not the name of this piece and all of the drawings are my own design hand drawn on the vase.


RE: LET THERE BE DRAGONS - Bill Holt - 01-04-2023

Holy Cow!  The drawings are amazing!  Looking forward to seeing more.


RE: LET THERE BE DRAGONS - arthropod98 - 01-05-2023

that's awesome!  
Yes

do you seal that to prevent smudging while you're doing the carving?


RE: LET THERE BE DRAGONS - Splinterz25 - 01-05-2023

(01-05-2023, 02:27 PM)arthropod98 Wrote: that's awesome!  
Yes

do you seal that to prevent smudging while you're doing the carving?

Thank you Bill, Great question arthropod.. I use the last parts of spray lacquer cans and just give the drawings a light mist to seal them it. I find this a great use for the bottom of a spray can, that I would not use on any project.


RE: LET THERE BE DRAGONS - arthropod98 - 01-06-2023

(01-05-2023, 05:06 PM)Splinterz25 Wrote: Thank you Bill, Great question arthropod.. I use the last parts of spray lacquer cans and just give the drawings a light mist to seal them it. I find this a great use for the bottom of a spray can, that I would not use on any project.

seems like a good use to me!  
Yes

looking forward to seeing the end result!


RE: LET THERE BE DRAGONS - Splinterz25 - 01-08-2023

Photo carving up date:  I didn't get as much done yesterday, that JOB thing got in the way. So I'm making progress lots of outline cutting and now boring to remove large sections. I also started some 3-D carving in a few places. If you have any questions please just ask.


RE: LET THERE BE DRAGONS - Cian - 01-08-2023

This is very cool 
Cool


RE: LET THERE BE DRAGONS - Splinterz25 - 01-09-2023

I was able to remove the large sections that had been bored and add some details.


RE: LET THERE BE DRAGONS - FrankAtl - 01-09-2023

That's going to be very cool Bruce! Can't wait to see the end result.


RE: LET THERE BE DRAGONS - Dusty Workshop - 01-11-2023

You are so creative!