+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: A Rebuild Project? (/showthread.php?tid=7372464)
A Rebuild Project? - bandit571 - 03-06-2023
A while back, I picked a cutting gauge at an Antique Mall....$4....Was a bit on the worn side..
[attachment=46629]
Lets see...end with the knife and wedge has split.....thumbscrew was stripped out, barely holding on.....and the head has a crack in it..
So...
[attachment=46630]
I do have some Ash stock for a new arm.....I went to Lowes this evening, bought a threaded insert and a new thumbscrew to match...
May try to glue the crack back together...not really wanting to make a new head...then, install the threaded insert, and the new thumbscrew.
Question being how long to make the new arm? I was thinking about MAYBE 12"?
I can chop out the mortise for the wedge and knife....maybe sharpen the knife?
Stay tuned....
RE: A Rebuild Project? - bandit571 - 03-07-2023
Last night..repaired the split head..
[attachment=46647]
Bought the brass insert, and got it install this morning..
[attachment=46649]
Made sure the new thumbscrew was long enough..
[attachment=46650]
These are the "old" parts..
[attachment=46651]
I did keep the wedge...the thumbscrew was too short to work any more...cutter needed replaced
[attachment=46652]
Squared up a 12" long piece of Ash scrap...and checked for fit..
[attachment=46653]
Slides easy enough, no binding...
Needed a mortise chopped...straight wall for the cutter, angled wall for the wedge..
[attachment=46654]
Slide the bar into the head...
[attachment=46655]
I think that will do just fine...Total cost? Just under $7 , for the gauge and the new parts...New cutter was a reground Xacto blade..