Woodnet Forums › › Active › Woodworking v
Table top finished
Thread Modes
Table top finished
Bope Offline
Member
Posts: 1,422
Threads: 0
Joined: Dec 2004
#7
02-27-2017, 08:14 AM
So here are pictures of the finished table top. I still need to paint the base. I was thinking of staying with a brown color.

[Image: Table%20top2.jpg]

[Image: Table.jpg]
Find
Reply
jteneyck Offline
Member
Posts: 12,876
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
#8
02-27-2017, 10:23 AM
That top is beautiful.  It looks like you mastered the EnduroVar in the end. 

John
Website Find
Reply
JGrout Offline
member
Posts: 29,152
Threads: 1
Joined: Aug 2002
#9
02-27-2017, 10:52 AM
I would say you did just fine. 

That is very intricate work and you nailed it.

Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Website Find
Reply
Bope Offline
Member
Posts: 1,422
Threads: 0
Joined: Dec 2004
#10
02-27-2017, 11:35 AM
The sides are still rough. I need to call General Finishes this week and see if I can get new material.
Find
Reply
jteneyck Offline
Member
Posts: 12,876
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
#11
02-27-2017, 03:09 PM
If you have good coverage and it's just rough from over spray, etc., then take some 1500 grit sand paper and buff it smooth by hand.  Or get some Micro Mesh pads.  If the sheen is off, go higher or lower on the grit.  

John
Website Find
Reply
Bope Offline
Member
Posts: 1,422
Threads: 0
Joined: Dec 2004
#12
02-28-2017, 07:43 AM
I will give that a try. I was worried about the changing the sheen. If I do mess it up I can always shoot another coat.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.